Syntax

What’s the correct syntax to get this to work in the GotoIf block.
I have a DB query:

select count(*)
from crs
where worktel=${CALLERID(num)}
or hometel=${CALLERID(num)}
or mobiletel=${CALLERID(num)}

Then I loop around until all the items are read out by SWIFT, using…

select item,status,que,price,job,statusnum
from crs
where worktel=${CALLERID(num)}
or hometel=${CALLERID(num)}
or mobiletel=${CALLERID(num)}
limit 1
offset ${count}

However in the GotoIf block I put:
$ “0”” rel=””>”${price}” > “0” and
($”${statusnum}” = “80” or
$”${statusnum}” = “90” or
$”${statusnum}” = “100” or
$”${statusnum}” = “110” or
$”${statusnum}” = “120” or
$”${statusnum}” = “130” or
$”${statusnum}” = “140” or
$”${statusnum}” = “150” or
$”${statusnum}” = “160” or
$”${statusnum}” = “165” or
$”${statusnum}” = “170” or
$”${statusnum}” = “190” or
$”${statusnum}” = “210” or
$”${statusnum}” = “280” or
$”${statusnum}” = “290” or
$”${statusnum}” = “360”)

So if the “statusnum” IS one of the numbers listed in my OR list – I need it to read out the price. However if the price IS greater than Zero and the ststusnum IS NOT listed – it STILL carries on and does NOT branch off as I would expect, so I can get SWIFT to read out just the status and NOT the price.

Where am I going wrong in my logic?

Cliff.